syntax: reboot!bootfile[!method...]
this echos bootfile to /dev/reboot, causing bootfile kernel
to be started.
when method is given, we first connect to the filesystem and
set bootargs so that bootfile can be loaded from the target
network or local fileserver.
note, when no bootfile is given, this causes the kernel to
reboot to bios.
the end condition port < offset+n could never become
false when offset truncated to 32 bit signed port is
negative. change the condition variables to unsigned
int.
msr's are not byte addressible, so advance reads by
one instead of 8.
Xpipefd wants the pipe descriptor to be closed in turfredir(), so
it pushes the redirection, but this breaks Xpopredir after normal
redirection. so we shuffle the Xpipefd redir to the bottom of the
stack.
- plumbsel()
- remove debug prints
- use smalloc() to convert to bytes
- fix spurious -1 close of plumb fd
- snarfsel()
- fix rune buffer leak in open error case
Ori Bernstein wrote:
> I finally got around to taking another shot at this vt patch. This change
> gets rid of implicit snarfing, and instead makes selection the way you
> select text for snarfing or plumbing. Select, then use a menu entry.
>
> It would probably be nice to have double click to expand the selection,
> rio-style, along with plumbing implicitly taking the current word, but
> that can be a separate patch.
>
> This change also punts on scrolling for simplicity -- it clears the
> selection instead of trying to handle the cases where the selection
> goes offscreen.
little amendments:
- fix line selection (point min/max inversion)
- clear selection when switching linesel/blocksel
- move selection on scroll
the arp table is per interface, so it is possible to have the same
netwrok on multiple physical interfaces, tho with different source
ip address. one example would be a ethernet and a wlan interface.
the mac addresses on these mediums can differ (arp proxying taking
place).
so provide our source address on the interface we received the
request on.
the previous change used the ifcaddr; which is correct; but due to a
oversight in the kernel, had to match the ip of the arp entry.
source address will always work.
unless relay agent (gaddr) is specified, dhcp requests need to
taget a local ip address on the incoming interface or broadcast.
clients might have multiple ethernet interfaces, so we need to
check if any of the ether= attributes in ndb matches. this is
done by passing lookupip() the attribute name and a expected
value and if a match is found, set Info.indb = 1.
remove tohex(), use encodefmt instead. avoid dynamcic allocation.
include interface device in log messages.
