plan9fox/sys/man/3/i2c

99 lines
3.0 KiB
Plaintext

.TH I2C 3
.SH NAME
i2c \- I²C Bus Interface
.SH SYNOPSIS
.nf
.B bind -a #J /dev
.PP
.nf
.BI /dev/ bus /i2c. n .ctl
.BI /dev/ bus /i2c. n .data
.SH DESCRIPTION
The I²C (Inter-Integrated Circuit) bus is a serial bus standard
invented by Philips.
It is used to connect chips over short-distances like on a motherboard
or between boards.
The bus requires only a single data signal
.IR SDA ,
a clock signal
.I SDC
and ground.
Devices on the bus have 7-bit or 10-bit addresses, which is
determined by the device (see the datasheet).
Every device monitors the bus and waits for the master to initiate
a transaction.
Each transaction starts with the master sending the target device address
with a direction bit and the device acknowledges each byte
received if its address matched.
Depending on the device, more bytes must be transmitted after the
.IR device-address .
For example, encoding a register number at a memory offset.
We refer to these bytes as the
.IR sub-address .
After the address phase, the data phase begins where
zero or more data bytes are either transmitted or received
depending on the transaction direction.
.PP
This driver supports multiple buses (controllers) to be registered
by platform specific code in the kernel.
Each bus is represented as a directory with a platform specific name.
.PP
Because all received bytes are acknowledged by target devices,
it is possible for the master to enumerate all existing addresses
on a bus, which is done when accessing the
.I bus
directory.
.PP
Platform specific code can also register individual devices,
supplying a meaningful device configuration.
It can also be necessary to manually register devices if
the device has been disabled by an enable signal or
otherwise inhibited during enumeration.
.PP
Each device appears as a control (
.BI i2c. n .ctl
)
and a data file (
.BI i2c. n .data
) in the
.I bus
directory
where
.I n
is the device-address in hexadecimal.
.PP
The data file is used to initiate transactions to the device.
The initial
.I sub-address
bytes sent are derived from the file position according to the device
configuration, and the length of the data phase is controlled by
the requested read or write size.
The requested size might be truncated by the driver if
the request exceeds the logical file-size.
.PP
The control-file provides access to the device configuration.
When read,
it reproduces this configuration in text form.
The following text lines are accepted when written to the control-file:
.TF "subaddress n"
.TP
.BI "subaddress " n
Sets the length
.IR n ,
in bytes, of the sub-address for the device
that is derived from the file-position of the data-file.
This can be set to zero if no sub-address bytes should
be generated by the driver.
By default, the sub-address length is 1.
.TP
.BI "size " n
Changes the logical size of the data-file to
.IR n .
Making sure the file-position is not exceeding this size.
.SH SOURCE
.B /sys/src/9/port/devi2c.c
.SH HISTORY
The file-interface has been inspired by infernos devi2c,
but with the addition of supporting multiple buses
and device enumeration.