we have to reset hwblank when switching drivers to
prevent the generic vgablank() to be called by
blankscreen().
remove code setting hwblank from vga drivers as
devvga will always force hwblank to be 1 or 0
depending on if the driver provides a native blanking
routine.
set hwaccel to 1 when the driver provides native fill
and scroll routines independent of softscreen being
disabled. this allows hw acceleration to be used when
softscreen gets switched off.
previously, we had to maintain 3 sets of pci vid/did's:
1) in /lib/vgadb for detection
2) in the userspace driver in aux/vga
3) in the kernel mode driver
this change makes the kernel mode driver more dumb in
the cases where possible. we let userspace do the pci
enumeration and if needed, it can set the pci address
of the vga card. kernel mode drivers can assume to get
the right pci device passed in scr->pci for enable()
and linear() functions and just do very basic sanity
checking before mapping framebuffer and mmio regions.
vgalinearpciid() was removed as userspace is responsible
to pick pci device.
theres a new vgactl message "pcidev" where userspace
can set the bus address. we initialize scr->pci in
vgareset() to the first pci graphics card found. this
should cover cases when an old aux/vga binary is used
that doesnt use the new pcidev message.
userspace drivers will now use the pci device that got
a match from /lib/vgadb and skip ther own enumeration.
this way, vga cards can be made to work by simply adding
an entry in vgadb with no need to modify userspace or
kernelspace drivers. this is not always possible if
the driver derives information from the specific card
model.
